The V-Tap Analog II is a hardware and software solution for the recording of telephone calls. The supplied hardware unit can record the audio from an analog telephone line or any telephone that works with a cord-connected handset.

V-Tap-Analog II Features:

• Recording: analog telephone calls and analog audio
• Caller ID detection: via DTMF or FSK if available
• SD-card slot: yes, storage of WAV files
• Wi-Fi: supported
• LAN: RJ45
• PABX: RJ10
• PHONE: RJ12
• Audio connector type: 3.5 mm circular TRS
• Connector function set by switch: Stereo OUT, Mono
• IN+OUT, Stereo IN
• Switch position#1: Stereo OUTPUT
• Switch position#2: Mono INPUT+OUTPUT
• Switch position#3: Stereo INPUT
• Level: 1- 700 mV RMS (software setting)
• Impedance: 2500 Ohm
• Bandwidth: 4 or 8 or 16 KHz
• Phantom power: 2.2V DC
• AGC: Limiter range>40 dB with Noise Gate
• Level detector range: Available, Range 0-250 mV RMS
• Primary use: Electret Microphone
• Level: 50 – 2000 mV RMS (software setting)
• Impedance: 150 Ohm
• Bandwidth: 4 or 8 or 16 KHz
• Primary use: Amplified Speaker
• USB Version: V2.0 High Speed (480 Mbps)
• USB Profile: Generic HID (VID: 0DE1 / PID: 5202)
• USB Current: 5V @ 500mA (Max. 3 W)
• USB Connector: Full size ‘B’- type
• Power Supply: USB powered
• Button: One button, see manual for button functions
• LEDs: Four LEDs, see manual for LED functions
• Dimensions (L x W x H): 137 x 81 x 30 mm
• Housing material: Silver and Blue, 4 pieces soft rubber footpads
• Weight: 150 grams
• Temperature Range: 0 – 40 °C
• Humidity Range: 10 – 90 %, non-condensing